鸭脖娱乐

? Set as home page | Add to collection | contact us
?
Product knowledge
·Current location: Home page ?>> Product knowledge
What you don't know about the internal structure of the salt spray corrosion chamber
Related introduction
Product
? inside the laboratory of salt spray corrosion test box:
Spray tower: the built-in glass nozzle is placed inside the nozzle, and the spray is diffused to the laboratory through the cone-shaped diffuser through the tower tube approach. Spray regulator: adjust the size of spray, increase the amount of spray added, reduce the amount of spray cut. The brine preheating tank is located at the bottom of the spray tower. The brine in this tank is written into the preheating tank through the brine make-up bottle. The water level of the preheating tank is controlled by the floating ball, which can actively control the water level. There is a drain outlet for cleaning at the bottom of the tank, which is controlled by a silicone plug. ?
? collector: the amount of mist ejected from the nozzle is put into a funnel cup of 80 cm 2 by self falling method, and then flows from the pipe to the measuring cup. Shelf: this rack is made of plastic steel, so the weight of the central point is not more than 2kg. If it is placed loosely, it can be accepted within 10kg. There are two rows of round holes on both sides of the shelf, which are used to place the storage rod at an angle of 15 degrees and 30 degrees from the vertical plane; filter: used to filter the impurities in the salt liquid to ensure that the nozzle is not blocked by impurities; heating water tank: this water tank is attached to the bottom of the laboratory, used for water heating, adhere to the stable temperature and humidity of the experiment, and its function of heating and heat preservation. ?
? Salt spray corrosion test box External laboratory:
Wet and dry bulb thermometer: read the temperature and humidity in the laboratory. It is made of stainless steel, which is used to measure the amount of water mist in the bottom of the tank. The function of the utility model is that the air is heated and humidified by the barrel, so that the air reaches the full humidity and then sprays at the nozzle. Brine make-up bottle: actively make up the salt liquid in the brine preheating tank; experimental cover: roof type 100 degree perspective cover, used to cover the upper part of the laboratory as a whole. ?
? pressure regulating valve: when the air pressure is too high or too low, it can adjust the laboratory pressure by the pressure gauge. Pressure gauge: the pressure shown by the pointer of this gauge is the pressure reached when the air is heated by the full air barrel to convey the nozzle pressure. Exhaust pipe: 21 / 2 "diameter pipeline. Contact this pipe to discharge fog outdoors. There should be no water accumulation, so that the fog can be discharged naturally. Drainage pipe: 1 / 2 "diameter pipeline, connecting the drainage pipe with the water drainage ditch to discharge the waste water. Make up for the normal use of water in the laboratory. ?
?
?